Xbox 360 Wireless controller with the IntensaFIRE installed. Works on a shooters games. Has 5 modes, 4 pre-set modes and the 5th mode is a user programmable mode. Games it works on: Halo Series, Gears of War Series, Call of Duty Series, Left 4 Dead Series, and All other FPS and fighter game.
What does the IntensaFire do?
The INTENSAFIRE modifies XBOX 360 controllers (CG, Matrix and wireless), allowing them to control 5-mode sleeper settings, and use customizable user programmable modes. It uses the existing Sync button to toggle modes, and on and off. It also enables dual rapid-fire- usable in all XBOX 360 games, including gamer favorites: Left 4 Dead, the Call of Duty series, the Halo series, the Gears of War series, and Street Fighter.
How is it better?
5-mode sleeper mod kits exist. Dual rapid-fire mod kits exist. The INTENSAFIRE mod kit has both. There are controllers on the market, prefabricated, that do what the INTENSAFIRE offers, each controller going for well over $100. We offer a mod kit that is extremely simple to install, taking no more than 3 minutes with minimal tools for less than 1/4th the cost of the prefabricated units. Other mod kits require drilling, wiring, gluing, and deconstruction of your controllers. The INTENSAFIRE only needs a few existing points to solder to connect the INTENSAFIRE flex board to the controller and you're ready to go!
The INTENSAFIRE is not intended for online use.
If you are thinking about whether or not you should buy the IntensaFire mod kit and modify your own controller or buy a controller with the IntensaFire already installed. Click here to view installation video and decide.
It has been brought to our attention that there was a misprint in the instructions that went out with the first batch of IntensaFIRE mod kits. In Step 7, it states that CG controllers use the left "Sync" connection, and Matrix controller use the top "Sync" connection. It should read:
"CG controllers use the TOP "Sync" connection" and "Matrix controllers use the LEFT "Sync" connection"
If you had connected yours using the improper "Sync" connection as described in the misprinted instructions, the good news is, nothing bad has happened. Just connect the proper point as outlined above.
The second wave of IntensaFIRE's will be packed with the proper instructions. So chances are, you haven't had this issue.
We are proud that our product is made in U.S.A. Creating jobs during hard times!
|
